Ultra Fine Grinding Mill can process carbon black materials. Our self-developed micro-grinding can process materials to a fineness of about 400 mesh. Micro-powder has high output, low energy consumption and good environmental protection. Micro-powder also has high output and low energy consumption. , the product has high fineness, high safety and reliability, clean, environmental protection and other technical advantages. When processing carbon black materials, if you want to process carbon black to ordinary grinding, you can use micro-grinding to complete, if you want to get For finer carbon black, you can use ultrafine mill to make Wencheng.
In the field of carbon black milling, some carbon black raw materials contain certain impurities. In order to obtain higher quality products, we will provide corresponding magnetic separation equipment according to customers' requirements. After magnetic separation, the purity of carbon black can be greatly improved. Then, after entering the mill to grind, a higher quality purity can be obtained, and then grinding into the ultrafine mill to obtain a higher quality carbon black product. When fly ash fly ash is mixed into concrete, it can not only replace cement and gravel aggregate, but also reduce the cost of concrete, effectively protect the environment, improve the workability of concrete, and improve the impermeability and sulfate resistance. And chemical corrosion resistance, which effectively improves the high temperature resistance of concrete and reduces particle separation and water precipitation.
When the ultrafine mill is working, the main motor drives the main shaft and the turntable to rotate through the reducer. The roller pin on the edge of the turntable drives dozens of grinding rolls to roll in the grinding ring raceway. The bulk material passes through the vibrating feeder and the tilting advance. The material pipe is evenly sent to the bulk tray of the upper part of the turntable. Under the action of centrifugal force, the material will be scattered to the periphery, and will fall into the roller path and be impacted by the ring roller. It will be rolled and ground. After three layers of loop processing, it will become powder. The micro-powder will suck the outside air into the body through suction. And the material after grinding is brought into the classifier, and the crude material of the impeller in the classifier is re-grinded, and the fine powder that meets the requirements enters the cyclone collector with the airflow and is discharged by the discharge valve at the lower part thereof. It is the finished product, and the airflow with a small amount of fine dust is purified by the pulse dust collector and discharged through the fan and muffler.